The Stated bases calculation importances constructive parameter vibration of the protector. Method of the calculation of importances constructive parameter vibration of the protector is Created with provision for superimposed on them functional restrictions of the quasi invariant systems with accuracy under weight mechanical and other object. Because of smaller number variable us to manage to change the target function by requirement equality modules of power, developed in the main spring and in patch acerbity.

The article is devoted to the structure and description development of the technical solutions which used in the stand design for studying the dynamics of the transport and technological machines operator vibration protection combined system which used in building. As a load-bearing elements of passive and active vibration protection systems are encouraged to use rubber-cord casing. Stand structure should allow to evaluate the contribution of both passive and active vibration protection system in the general process of oscillations suppression.

The article has considered the problem of technical state forecasting for universal control fuel pump and gas turbine engine in service. The subject matter of this article is the analysis of extreme forecasting method application for providing the assured forecasting of fuel pump technical state. This method makes it possible to forecast technical state with using of measurements results, obtaining for a long time trials of universal control fuel pump on half-natural model test stand and during subsequent planned tests. The forecasting has been performed without statistic distribution analysis of measurements results. The results of investigation may be used for forecasting of different technical system states.

The short survey and analyze of diesel operation indexes working on liquid fuels is shown. The analytic and graphic interpretation of the indicator diagram, characteristics of fuel injection and heat release, harshness of working cycle are given. The influence of standard and alternative fuel types on diesel operation parameters is analyzed by experimenting on a high-speed diesel engine test bench. The results of diesel tests on diesel fuel and liquefied oil gas mixes are examined. The modelling results of diesel working on a mix of liquefied oil gas and standard diesel fuel are analyzed.

Traffic police statistics show that the most common types of road accidents began hitting vehicles, most of which occur at crossroads of roads. An objective investigation of circumstances traffic incidents and identification the true culprit of the accident is the main task of the persons investigating of the circumstances of the accident. However, the investigation into circumstances of incident is inextricably linked to a clear understanding where, in what place there was a traffic accident and who of the participants used a preferential right to movement. The solution of these issues is often hampered due to insufficiently precise wording of the terms used in the Rules of the road Russian Federation. In particular, this disadvantage concerns the term "crossroad." In the various literature devoted to the issues of traffic safety, examples are given that allow to determine the configuration and boundaries of the crossroad. However, the vast majority of the examples based on the simplest form of three - or four-way crossroad. In this work, the authors analyzed requirements and came to the conclusions that the necessity of changing the existing term "crossroad".lwe

The article considers the estimation technique of information intensity of the tracklaying vehicle driver's work. It is based on the estimation technique of the information contentof both anisolated irregularity and a track section as a whole. This technique allows predicting the value of the average speed of the tracklaying vehicle provided with driver'sabilities to process and implement the incoming information on the ambient traffic conditions. The article can be useful forre-searchers, engineers and techniciansregardingvehicle handling trial, who deal with practical aspects of tests and evaluation of ergonomic vehicle properties and, in particular, ergonomics of the driver's compartment.

This article analyzes the spatial representations from the standpoint of an interdisciplinary approach. Along with the views of theorists of architecture, the author reveals the contribution to the realization of the essential characteristics of the space representatives of such fields of knowledge as geography, psychology, art history, philosophy, and cultural studies. Consideration of space from the standpoint of various scientific disciplines and allows schools to empower its study.

The organizational and technological issues of the transport documents provide material resources construction projects considered without sufficient justification. In the article the task of planning the volume of deliveries agreed with the construction company's internal capabilities and external conditions is formulated in the form of a mathematical model of linear programming. The principles of planning, the concept of the quality of the plan, formalized internal and external constraints on the choice plan. Model developed by the authors plan will improve the level of organization of construction management flows, ensure the continuity and uniformity of the work of production and consumption of materials, products and structures.

The article analyzes the advantages of the methodology of the system approach in the study, design, construction and operation of facilities. On the basis of the general theory of systems obtained generalized model of roads in the form of a set-sti basic principles: structural, performance, reliability and ef-fectively-sti. This hypothesis is used system-wide compliance with the principles and the Half-dressing design of roads and their networks. The conclusion about the possibility of using the obtained models in the design of the road network at different levels of development in response to changing conditions.

In the article discusses the results of laboratory tests coal ash and slag mixture from the ash pound of Omsk's TPP-4, working on the Ekibas-tuz coal. In the course of these studies identified the strength characteristics of this man-induced soil depending on the degree of compaction and moisture content. Suitability as a soil material for the construction embankments, subgrade of roads, and as the Foundation of buildings and structures was evaluated. The empirical dependence of the properties of ash and slag mixture from moisture and maximum dry density were obtained. Comparison of strength characteristics of ash and natural soil from our region was also carried out

In the paper the results of steam curing characteristics in nanostructured binder based foam concrete and their comparison with analogues are presented. Also the comparison study of parameters of vapor permeability,sorption hymidity,capillarity rise, heat conductivity (in dry service conditions) is realized. Effect of cellular composite structure on properties and reinforcement process of foam concrete is studied.

The article studies the stress-strain state of multilayer laminated timber deck of cross planks, which are a supporting element in slab glulam bridge superstructures. Timber slab from an odd number of cross-layer boards can be considered homogeneous thin plate with different properties in different directions; on the other hand it represents the multilayered structure of welded (glued) homogeneous anisotropic layers.The work assesses the stress-strain state of multilayer timber slabs in relation to slab span structures of bridges.

One of the essential stages of the system management information security is audit of information security systems in accordance with state and industry standards. The aim of this work is the automation of a workplace of the employee of the Department of information security of banking organizations, with software development for the assessment of conformity of documents containing evidence of the Bank's activities in IB, in the framework of the standard and recommendations to the standard Central Bank of the Russian Federation (RF) STO BR IBBS 1.0-2014 and RS BR IBBS-2.0 (2) -2014. Presented in detail one of the modules of the system - an automated document library in the sphere of information security.

The current stage of development of processes of modeling systems characterized by an increase of functional saturation. Modeling work processes excavator hydraulic drive is a complex hierarchical task, as in the performance of technological operations of the excavator is necessary to record and analyze a large number of factors and parameters, dynamically changing over time. The article reflected the description of the developed complex systems of the pilot studies shovel energy efficiency through the integration of support virtual systems, has a wide range of functionality and reduces the complexity of carrying out experimental research. Keywords. watching system, algorithm, resistance forces, kinematic couple.

In the article the methodical approach to the evaluation and control of efficiency of functioning of vertically integrated oil companies. The concept of balanced development of vertically integrated oil companies as a basis for effective development. Developed a matrix for assessing the efficiency and competitiveness of vertically integrated companies and its business segments

The relevancy of the influence research of the environment factors on the manufacturing strategy of the gas producing enterprise is presented in the article. Factor classification and their characteristics are given here. Matrix of the factor influence estimation is developed per 5-point score and the approbation of the offered ranking matrix has been made.

In the article the problems of management in the service sector and directions of their solutions. The main problems in the management in the service sector are the lack of adaptability of the developed management solutions to the ever-changing environment, the existing methods and technologies do not allow with sufficient accuracy to predict change, to present the results in graphic form, and limit the use of the creative potential of the head. The key areas to solve problems and improve the management of the service sector is the introduction of modern methods of simulation, cognitive visualization options theory in management processes in this area, the development of technology and the formation of the optimal use of the resource potential of the processes in this field. On the basis of these directions set by the author, and the problem is solved in the monitoring field of study with the application of mathematical methods, the regularities of providing social services-oriented non-profit organizations. The results can be used to develop management tools in the service sector. Keywords. Scope of services aimed to improve the management in the field of services, outreach services, and monitoring.

Dependence between age structure of labor power and efficiency of implementation of creative potential of a creative class is disclosed. Influence of urban saturation of the country on development of creative economy is studied. Possibilities of the countries with narrow specialization to transition to a phase of creative development through traditional industries are revealed. It is proved that the level of technical progress is to some extent determined by the cost of separate production factors.

The article discusses the problem of accounting for risk and uncertainty in decision-making on investment. At the same time the analysis of existing methods for risk assessment of investment projects. The paper presents the definition, the author's classification of the risks inherent in investment projects, delimiting risks in groups and stages of the implementation of the investment project. The authors have developed a phased method of accounting risk by incorporating risk premium in the discount rate, combines qualitative and quantitative risk assessment methods.